Product Range

The Keypad Model XMB 711

Keypad Model XMB 711

The Keypad Model XMB 711 is a battery operated, wireless alphanumeric keypad designed for configuring/programming and operating VIDEOFIED® security systems.

The keypad consists of a liquid-crystal (LCD) display with two 16-character lines, multi-function push buttons, a panic alarm button, a built-in sounder, and S2View® spread spectrum, videofied, interactive, encrypted wireless circuitry for secure two-way communication with the control panel. Read more >

The LCD display provides easy to read messages and goes out after 30 seconds of no keypad activity, to conserve battery power. Pressing any button (except the panic alarm button) restores the display.

The keypad allows complete alphanumeric programming of all system settings/parameters in VIDEOFIED® security systems. S2View® spread spectrum, videofied, interactive, encrypted wireless circuitry effectively makes the keypad a mobile programmer that can be used anywhere within the installation site during system programming. Easy to understand display text guides you through programming, prompting you for simple yes/no or data entry responses. The left and right arrow buttons cycle through menus or values until the desired choice is displayed. Alphabetical entries are done using the 0 - 9 buttons and can be in lowercase, uppercase, or a combination of both. Complete punctuation symbols are also available for data entries such as website/IP addresses and component location naming.

Arming/disarming the system with the keypad is easy. For example, the 1 and 2 buttons just below the display can be programmed to arm a specific part of the premises just by pressing the button once, then it will prompt you for your code. The house outline button just below the display can be used to arm the perimeter device of the premises in the same manner.

The keypad is typically installed near entry/exit doors to allow system users enough time to arm and exit the premises, and to enter and disarm the system before time delays expire. When the system is armed, the built-in sounder emits a series of exit delay beeps to remind the user to exit before the beeps stop. Upon entering the armed premises, the built-in sounder emits entry delay beeps to remind the user to disarm the system to avoid an alarm. A dual tamper function provides detection for both keypad cover and wall tamper.

The keypad is powered by three lithium batteries that can last up to four years or more, depending on the amount of keypad activity. The keypad transmits a check-in signal every eight minutes that includes its unique identification code, along with the tamper condition, serial number, date of manufacture, software revision and battery status. You can install up to three keypads on a system.

Installation/Mounting
Keypad/Base: One screw secures keypad to base; three screws secure keypad base to mounting surface.

Electrical Data
Power requirements Three 3.6V batteries Battery type Lithium, LS14500 Battery life Up to 4 years RF technology S2View® Radio type Spread Spectrum Bidirectional RF Operating frequency 868/915/920 MHz Transmission security AES algorithm encryption Supervision Polled signal every 8 minutes Antenna Integrated Tamper detection Wall and cover tampered Display type Liquid-crystal (LCD) Display size Two lines, 16 characters each Display backlighting Automatic Built-in sounder Emits entry/exit delay beeps, alarms Panic button One (can be disabled) Operating temperature ) F° 40 1/°23(C ° 0 4+/°0 Maximum relative humidity 70%, non-condensing Approvals CE / EN50131 / EN300220 / INCERT/ IDA / NCP (CMA200) FCC (CMA600) A-Tick (CMA700)

Physical Data
Material ABS-ULV0 Dimensions 177 mm x 95 mm x 37 mm (LxWxD): 7 in. x 3-3/4 in x 1-1/2 in. Weight 255 g/ 9 oz. (without batteries).