Product Range

Control Panel XTIP 730

Control Panel XTIP 730

The Control Panel Model XTIP 730 is a Videofied wireless, battery operated security system control panel.

The control panel is designed for residential and small commercial security applications where video verification is needed or desired. Read more >

The control panel is powered by eight 1.5-volt alkaline batteries that last up to four years, with normal system activity. A built-in siren provides status beeps. The embedded cell modem communicator reports to the monitoring station and and enables 2-way voice communication over cell to the monitoring station.

A dual-tamper function is active 24 hours, whether or not the system is armed. An alarm occurs if the control panel cover is removed, or if the control panel is removed from the mounting surface.

With the embedded touchpad the user can arm, disarm the system and review past events and system status. Under the TouchPad an integrated proximity card reader that can be used to arm and disarm the system without using the TouchPad. The proximity card/tag arming system is designed to maximize operator convenience.

Supervised Wireless Technology
The XTIP 730, along with all Videofied devices utilize patented S2View® - Spread Spectrum, Videofied, Interactive, AES Encrypted Wireless technology, providing optimum signal integrity and security. Bi-directional RF communication paths between all system devices and the system control panel assure high signal reliability.

Integrated antennas eliminate protruding wires or rods cumbersome to install and unsightly to consumers, and if damaged could lead to potential system communication problems.

The panel supervises every device (excluding the remote keyfob) to validate current open/close state, tamper condition, serial number, date of manufacture, firmware revision, and battery status.

Installation/Mounting
Control Panel/Base One screw secures control panel cover
to base; four screws secure
control panel base to the wall

Embedded touchpad Data
TouchPad to arm/disarm the system with event display
Automatic back light
3 arming keys / symbols
3 panic buttons
Event symbols
Embedded voice speaker and microphone
No specification mentioned on Proximity Card arming/disarming

*4 year battery life based on normal operation
calculations of 2.5 video/alarms per month, daily opening/closing reports
internal supervision every 8 minutes and daily periodic test signals

Electrical Data
Power requirements Eight 1.5V batteries
Battery type Alkaline, D size, LR20
Battery life Up to 4 years*
RF technology S 2View®
Radio type Spread Spectrum Bidirectional RF
Operating frequency 868/915/920 MHz
Transmission security AES algorithm encryption
Radio jam detection Yes
Supervision Yes
Antenna Integrated
Tamper detection Wall and cover tamper detection
Siren output 105 dB @ 1 meter
Siren duration programmable, 3 minutes maximum
Programming Alphanumeric Keypads or
Frontel remote control Software
Devices per system 19 per system
Access codes 20 maximum
Installer codes One (for system programming only)
Security levels 3
Arming modes : 2
Special arming modes 4 (Area 1 predefined from factory for
entry/exit delay. Areas 2, 3, & 4 programmable.)
Communication formats Voice, Email or IP
Communicator type GPRS and GSM cell
2 way-voice Full duplex, bi-directional
Dialing DTMF
Protocols Frontel
IP stack IP, TCP/IP, HTTP, SMTP, PPP
Voice alarm transmission Up to 3 phone numbers
Voice server Pre-recorded messages
Remote maintenance Frontel Downloader protocol only
VIdeo transmission: By Frontel protocol to
central monitoring station
Video format MPEG V1.0 video file
Video file size 220 Kbytes
Video framing 5 frames/second
Image format JPEG
Image size 320 x 240 pixels
History/Event Log 4,000 events stored in flash memory
Operating temperature 0°/+40°C (32°/104°F)
Maximum relative humidity 70%, non-condensing
Approvals CE / EN50131 / EN300220 / INCERT / IDA / NCP (Europe)
CP-01 / UL / FCC (USA)
A-Tick (Australia)

Physical Data
Material ABS-ULV0
Dimensions 225 mm x 180 mm x 55mm
(LxWxD):9in. x 7in. x 2-1/6in.
Weight 520gr (without batteries) / 1600gr (with batteries)